Português (Brasil)

Disk II

1978.07

Contexto histórico

The Disk II Floppy Disk Subsystem is a 5.25-inch floppy disk drive designed by Steve Wozniak at the recommendation of Mike Markkula. Apple did not originally offer a disk drive for the Apple II, which used data cassette storage like other microcomputers of the time. It was announced in June 1978 at a retail price of $495 U.S. for pre-order; it was later sold for $595 U.S. including the controller card (which can control up to two drives) and cable. The initial Disk II drives (A2M0003) were modifications of the Shugart SA-400, which was the first commercially available 5.25-inch diskette drive. Apple purchased only the bare drive mechanisms without the standard SA-400 controller board, replaced it with Wozniak's disk interface board design, and then stamped the Apple logo onto the faceplate. Wozniak called the resultant Disk II system "my most incredible experience at Apple and the finest job I did", and credited it and VisiCalc with the Apple II's success. Early production at Apple was handled by two people, and they assembled 30 drives a day. By 1982, Apple switched to Alps drives for cost reasons. The drive connected to the controller card via a 20-pin ribbon cable; the controller card was plugged into one of the bus slots on the Apple II's logicboard. DB-19 adapters were eventually available for use with Apple's later connector standard. Up to 14 drives could be attached to one Apple II or Apple IIe computer - two drives per controller card, one card per slot, and there were seven usable slots per computer. Apple's printed manuals suggested using slot 6 for the first controller card.

Fonte: Wikipedia

Especificações principais

Peso1.36 kg

Especificações completas

Informações básicas

Data de Lançamento1978.07
Descontinuado1984.05
Preço original$495 (na pré-venda do controle) $595 (no lançamento do controle)
Status de suporteObsoleto

Chip e armazenamento

Capacidade113.75 KB (Apple DOS 3.2.1) / 140 KB (Apple DOS 3.3 and ProDOS)

Conectividade

PortasNenhum
ConexãoCabo flat de 20 pinos ou DB-19 (com adaptador)
Requisitos de sistemaApple II, Apple II Plus ou Apple IIe com placa de interface Apple Disk II; Apple IIc ou Apple IIGS com adaptador DB-19 (não compatível com o Apple IIe Card para Macintosh)

Corpo e dimensões

Tamanho e peso146 mm × 203 mm × 83 mm,1.36 kg

Cor

Cores disponíveis

Identificador de modelo

Números de modeloA2M0003
Número de pedidoA2M0003 (without controller) A2M0004, A2M0044 (with controller)